Solvent dependent conformational isomerism and ligand oxidation of novel Ru(II) cyclen complexes

The synthesis of cis-[Ru(II)(cyclen)(L)(x)](n+) (cyclen = 1,4,7,10-tetraazacyclododecane and L = 2,2'-bipyridine (bpy), phenanthroline (phen) or 4-cyanopyridinium (4-NCpyH(+))) is reported. The freshly prepared complexes are stable in aprotic solvents and cyclen undergoes oxidative dehydrogenation reaction at high pH. These compounds also present solvent dependent conformational isomerization.     

Quantitative analysis of 2-furfural and 5-methylfurfural in different Italian vinegars by headspace solid-phase microextraction coupled to gas chromatography-mass spectrometry using isotope dilution

A new method was developed for the determination of 2-furfural (2-F) and 5-methylfurfural (5-MF), two products of Maillard reaction in vinegar, with head-space solid-phase microextraction (HS-SPME) coupled to gas chromatography-mass spectrometry (GC-MS). A divinylbenzene (DVB)/carboxen (CAR)/polydimethylsiloxane (PDMS) fibre was used and SPME conditions were optimised, studying ionic strength effect, temperature effect and adsorption time. Both analytes were determined by calibration established on 2-furfural-d4 (2-F-d4). The method showed good linearity in the range studied (from 16 to 0.12 mg/l), with a regression coefficient r2 of 0.9999. Inter-batch precision and accuracy were found between 14.9 and 6.0% and between -11.7 and 0.2%, respectively. Detection limit was 15 microg/l. The method is simple and accurate and it has been applied to a series of balsamic and non-balsamic vinegars.     

Quantum chemical evaluation of protein control over heme ligation: CO/O2 discrimination in myoglobin

Control of O2 versus CO binding in myoglobin (Mb) is tuned by a distal histidine residue through steric and H-bonding interactions. These interactions have been evaluated via Car-Parrinello DFT calculations, whose efficiency allows full quantum mechanical treatment of the 13 closest residues surrounding the heme. The small (8 degrees ) deviation of the Fe-C-O bond angle from linearity results from the steric influence of a distal valine residue and not the distal histidine. H-bond energies were evaluated by replacing the distal histidine with the non-H-bonding residue isoleucine. Binding energies for CO and O2 decreased by 0.8 and 4.1 kcal/mol for MbCO and MbO2, in good agreement with experimental H-bond estimates. Ligand discrimination is dominated by distal histidine H-bonding, which is also found to stabilize a metastable side-on isomer of MbO2 that may play a key role in MbO2 photodynamics.     

Heme-protein active site models via self-assembly in water

[structure: see text] Water-soluble models of heme-protein active sites are obtained via the self-assembly of cationic porphyrins 1 and tetrasulfonato calix[4]arene 2 (K(1.2)() = 10(5) M(-)(1)). Selective binding of ligands either outside or inside the cavity of assemblies 1.2 via coordination to the zinc center has been observed. Small ligands such as 4-methylpyridine and 1-methylimidazole are encapsulated, while the bulkier caffeine is bound outside. Assemblies Co-1.2, in which the Zn porphyrin moiety has been replaced by a Co(II) porphyrin, can act as O(2) carriers.     

Preparation and self-assembly of chiral porphyrin diads on the gold electrodes of quartz crystal microbalances: a novel potential approach to the development of enantioselective chemical sensors

Porphyrin diad 1 was synthesized by reaction of the acyl chloride of porphyrin 2 and trans-1,2-dithiane-4,5-diol. The Co complex of this diad was studied as a potential enantioselective receptor for chiral recognition in solution and in the solid state. In solution both enantiomers of limonene induce significant changes in the visible and circular dichroism (CD) spectra of [Co2(1)], while a different behavior is observed in the case of the enantiomeric pair of trans-1,2-diaminocyclohexane. A different efficiency of [Co2(1)] chiral recognition is obtained for these compounds, with a remarkable degree of enantiodiscrimination observed in the case of limonene. Self-assembled monolayers of [Co2(1)] were deposited onto the gold electrodes of quartz crystal microbalances to be used as sensing materials of nanogravimetric sensors operating in the gas phase. The enantiodiscrimination properties of these sensors towards the enantiomeric pairs of chiral analytes have been studied. While in the case of analytes bearing donor ligand atoms we did not observe a remarkable enantioselectivity, a significant degree of chiral discrimination was observed in the case of limonene; this result is particularly encouraging for the potential development of enantioselective chemical sensors for use in an array configuration.     

2-Methylisoxazolin-5-ones III. Curboxylic. Acids and their Derivatives

Carbethoxy-substituted 12-methylisoxazolin-5-ones and several functional derivatives have been prepared. Spectral properties of the corresponding carboxylic acids are discussed. These acids ant stronger when the carboxy group is in position 3 than when in position 4 of the heterocycle.     

Synthese, 13C-NMR-Spektren und räumliche Struktur von ‘Push-Pull’-Diacetylenen

Synthesis, ¹³C-NMR Spectra, and X-Ray Investigation of ‘Push-Pull’ Diacetylenes Phenyl-substituted ‘push-pull’ diacetylenes 1f and 1g have been prepared by acetylation and benzoylation of the appropriate lithiodiynylamines 4 (Scheme 2). ¹³C-NMR spectra of diacetylenes 1a–g (Table 1) are discussed with respect to the expected polarisation of the diacetylene unit by ‘push’ and ‘pull’ substituents. X-Ray investigations of 1c , 1e , and 1f have been performed in view of the planned solid-state polymerisation of ‘push-pull’ diacetylenes. In the crystalline state, diacetylenes 1c and 1f are stacked, however, the stacking parameters do not allow a solid-state polymerisation.     

Impact noise and the equal energy hypothesis

The equal energy hypothesis (EEH) was evaluated over a limited range of conditions by exposing four groups of chinchillas to impact noise (200-ms B duration) presented at a fixed rate of four impacts per second. The intensity of the impacts (107-125 dB peak SPL) and the duration (120-1.87 h) of the four exposure conditions were counterbalanced so that the four groups received the same total energy. The traumatic power of the exposures was assessed by measuring the threshold shift of the auditory evoked response and the amount of hair cell loss. Exposure between 107 and 119 dB were consistent with the EEH in that they produced roughly the same amount of permanent threshold shift (less than 20 dB) and hair cell loss (less than 20%). However, the 125-dB exposure produced substantially more threshold shift and hair cell loss than the three lower intensities. Thus, the EEH may be applicable only at lower impact intensities; above a "critical intensity" the amount of damage increases significantly.     

Ligand dynamics and reactivity in trimetallic clusters

The general relationships between trinuclear cluster reactivity and the ligand dynamical processes in these systems are explored. Three specific mechanistic studies are presented: (1) the rate and stereochemistry of ligand addition to ₃-imidoyl complexes, (2) the factors influencing the rate of carbon-hydrogen bond activation in ₃-alkyne complexes, and (3) the origin of anomalously large kinetic deuterium isotope effect in metal to ligand and ligand to metal hydrogen transfer in trinuclear and binuclear complexes. In all three cases, the current state of the mechanistic studies are summarized and the possible rate of specific ligand dynamical processes in controlling the mechanism are put forth.     

Fast atom bombardment mass spectrometric analysis of the partial ozonolysis products of poly(isoprene) and poly(chloroprene)

The low molecular weight compounds formed by partial ozonolysis of poly(isoprene) and poly(chloroprene) were analyzed by fast atom bombardment mass spectrometry (FABMS). In the poly(chloroprene) case, the ozonized mixtures were treated with piperidine before the MS analysis to transform in amide end groups the reactive acyl chlorides formed by the cleavage of double bonds along the main chain. Only one family of compounds having carboxyl and ketone or carboxyl and amide end groups were obtained from the ozonolysis of poly(isoprene) and poly(chloroprene), respectively. The assigned structures were confirmed by FAB-MS analysis of the GPC separation fractions [poly(chloroprene)] or by FAB-MS of the KOH-doped ozonolysis mixtures [poly(isoprene)]. It has been also ascertained, by GPC experiments, that poly(chloroprene) decomposes more rapidly than poly(isoprene) and poly(butadiene).